So i’ve installed the bl touch on the ender 3 max with your latest firmware for the 4.22 board
however all the install guides and info i’ve found on the internet do not match the current firmware build menu options (some have a prepare sub menu, others have a z probe wizard, etc)
i have measured my offsets manually, x is +52, y -14
with those offsets it puts the bltouch probe right in the center of the bed when i auto home
i keep getting the message “err too far” on the console, trying to find a way to adjust the z offset in home offsets. when the probe tip as well as the nozzle is over 15mm away from the bed.
the auto bed leveling does go around the bed with the extra probe touch down points (was going to be a request but you already had it done, thanks!)
any info would be appreciated. oddly not a lot of info on the ender 3 max out there for a bl touch setup that isn’t outdated.